This switch is commonly installed in the +12 volt feed wire to an electric fuel pump, connected to the closed position contacts (NC).
In the event of a crash or hard shock, the switch contacts will open, shutting down the fuel pump and switching on a warning light telling you that the switch has been activated or even a GPS distress locator.
To reset the switch just press the rubber diaphragm.
10 Amp contact rating.
Use with a relay if your fuel pump load is greater than 10 Amps.
360 degree sensing.
See more on YouTube
Used on many BL vehicles, Part No: WQT100030
Use our connector plug #NASPLG3
NOTE: THIS SWITCH MUST BE MOUNTED ON A VERTICAL PANEL WITH THE RUBBER DIAPHRAGM FACING UPWARDS
INERTIA SAFETY SWITCH #INERSW
Reviews
There are no reviews yet.